Johns Manville Spray Foam Insulation Nationwide | Walt’s Insulation

Johns Manville Spray Foam Insulation in Glendale: What to Know First

We install and service Johns Manville spray foam insulation throughout Glendale, and most open-cell or closed-cell jobs are completed within one to two days depending on square footage. As an independent Johns Manville service provider, we’re not tied to a corporate playbook, which means honest pricing measured per board foot and no push to replace what can still be repaired. If you have a Johns Manville foam job that isn’t holding temperature, has pulled away from the framing, or was never installed right in the first place, call (747) 246-7237 and a live person will pick up. This page is for Glendale homeowners who own a Johns Manville product and want someone who actually knows how that material behaves in our climate, not someone reading off a spec sheet.

Call (747) 246-7237

How Johns Manville Products Fail - and How We Fix Them

After 25 years in attics and crawl spaces across Glendale, we see the same failure patterns repeat. Here’s what actually goes wrong with Johns Manville spray foam, and what we do about it.

• JM Corbond III closed-cell shrinkage at the sill plate. Corbond III is a solid product, but in Glendale’s dry heat, we regularly find it pulling back from the mudsill where the foam meets concrete. That hairline gap creates a thermal channel and a rodent entry point. Our fix is cutting back the failed edge cleanly, refoaming with a compatible closed-cell, and sealing the transition with a flexible air barrier so the joint can move without cracking.
• JM Corbond II open-cell odor that never cured out. We get called into Glendale homes where a previous crew sprayed Corbond II and left a chemical smell that lingers for months. The usual cause is off-ratio application: too much isocyanate, not enough resin, or spraying too thick in one pass so the core never fully off-gassed. You don’t have to live with it. We test the density with a core sample, and if the foam is suspect, we remove the affected sections and respray with proper ratio control and temperature limits. Fresh foam, no smell.
• JM Corbond Performance 2.0 lifting off the roof deck. In Glendale attics with tile or shingle roofs, we see Performance 2.0 delaminate from the sheathing when the deck was dusty or damp at time of spray. The foam loses adhesion in sheets, which means your thermal barrier is doing almost nothing. We strip the unbonded foam, prep the deck surface properly, and reapply in lifts no thicker than the manufacturer’s maximum so the next layer bonds like it should.
• Open-cell foam that went brittle in a vented attic. Some Glendale homeowners got open-cell sprayed directly under a hot roof deck in a vented attic, which is a misapplication. Open-cell needs an air-sealed, conditioned space. Constant 140-degree attic air dries it out and it crumbles at the edges. We evaluate whether the attic should be converted to a sealed assembly with proper ventilation adjustments, then install the right open-cell or closed-cell foam for that configuration.
• Rim joist foam with rodent damage. Glendale has rats. They chew through open-cell foam at the rim joist like it’s cotton candy. We remove the chewed material, seal the exterior entry point, and reapply closed-cell foam around the rim, which is dense enough that rodents typically leave it alone. Then we rodent-proof the surrounding area so you aren’t feeding the neighborhood wildlife.

Our Johns Manville Spray Foam Insulation Process

Every Johns Manville job in Glendale follows the same discipline. No shortcuts, no guesswork.

1. 1
   Call and talk to a person. You call (747) 246-7237, we answer. We ask about the space, the symptoms, and the existing insulation. If you have a written estimate from anyone else, we’ll give you a free second opinion.
2. 2
   On-site assessment. We inspect the attic, rim joists, crawl space, or walls. We check depth, density, adhesion, and whether the original foam was installed to Johns Manville specifications. You get the honest answer, even if it’s “this doesn’t need replacing.”
3. 3
   Plan and price. We tell you exactly what we’ll do, what materials we’ll use, and what it costs per board foot. No vague “insulation service” line on the invoice.
4. 4
   Prep and protect. We mask off the work area, ventilate properly, and make sure the space is dry and clean so the new foam bonds. If we’re doing a roof deck in a Glendale attic, we confirm surface temperature before we ever pull the trigger.
5. 5
   Spray and check. We apply the foam in proper lifts with the right mix ratio, then check depth and density with core samples before we leave. The job isn’t done until the numbers match the spec.
6. 6
   Cleanup and Done Right Promise. We leave your home the way we found it, minus the insulation problem. Every job is backed by our lifetime workmanship guarantee: if it’s not done right, we make it right.

What Johns Manville Spray Foam Insulation Costs in Glendale

Spray foam pricing in Glendale runs by the board foot, and the numbers below reflect what we see on real bids around the city.

• Open-cell (Corbond II or similar) attic application: $1.80 to $2.75 per board foot installed, typical 1,200 sq ft attic at R-38 runs $3,500 to $5,800.
• Closed-cell (Corbond III) rim joist package: $2.75 to $4.00 per board foot, a full rim joist on a 1,500 sq ft crawl space usually lands between $1,800 and $3,200.
• Garage ceiling spray foam: $2.00 to $3.00 per board foot depending on open-cell vs closed-cell, most single-car Glendale garages fall between $900 and $2,200.
• Spray foam roof deck on a flat Glendale roof: $3.50 to $5.50 per board foot closed-cell, with most homes running $6,000 to $14,000 depending on deck size and accessibility.
• Removal and replacement of failed foam: Add $1.00 to $2.00 per board foot for tear-out and disposal, more if the attic has tight access.

What moves the price? Attic access, how much old foam needs to come out, and whether we’re working in a confined crawl space or a wide-open garage. Seniors and veterans always get 10% off, and there’s no trip charge inside our service county. Call (747) 246-7237 for an exact number. Estimates are free.

Why Glendale Homeowners Call Walt’s Insulation for Johns Manville Work

Walt Brenner has been doing insulation work since 2000, and we’re the one down the road, not a national chain with a rotating crew and an 800 number. You’ll see our truck parked near the Americana on Brand more often than not. Every technician who walks into your Glendale home is background-checked and in uniform, and every call is answered by a real person, 24/7. We install Johns Manville because it’s a good product, but we also work with Owens Corning, Rockwool, Icynene, CertainTeed, Demilec, Knauf, and GreenFiber, plus Reflectix for radiant barrier applications. If your job calls for a different material, we’ll tell you. The lifetime Done Right Promise covers the workmanship on all of it. We’re a licensed, published-address business with a real owner who stands behind the work. Do it right the first time or you’ll be doing it twice, and the second time costs more.

FAQs